Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
Adaptor for
Round Wire Brush
Removes adhesive residue from painted metal surfaces
COMPONENTS
1
Output Shaft
2
Abrasion Protection
3
Abrasion Protection
4
Handle
5
Speed Regulator
6
Air Inlet
7
Safety Lever
8
Trigger Lever
9
Fixing screw for Abrasion Protection (2)
PREPARING
1. Remove the sealing cap from the air inlet (6) and remove the Allen screw of the output shaft (1).
2. Mount the quick coupling nipple on the air inlet (6).
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger lever (8) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Check the function of the device by turning the safety latch (7) and pressing the release lever (8).
7. Disconnect the device from the compressed air source again.
ATTENTION
If working on painted or other sensitive surfaces, the eraser may not be used a long time or with high
pressure at a same point on the surface. Surfaces or coatings can be damaged.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Round Wire Brush
Straight, fine
Removes Paint, Rust, Under Body Protection, etc.
Eraser Disc
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Round Wire Brush
angled, fine
Abrasive Disc
Removes Paint, Rust, etc.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Round Wire Brush
angled, rough
Publicidad
