Publicidad
Idiomas disponibles
Idiomas disponibles
WALL MOUNTING INSTALLATION
•
To mount on the wall, drill two10mm diameter holes 538/615/675/696mm
with the vent hole on the top of the cooker hood in the middle as below
picture. Make sure the hood is aligned directly over the hob.
•
Insert two plastics wall plugs(supplied) into the holes.
•
Insert two screws into the upper two plastic wall plugs and
tighten them leaving 3mm protruding from the wall.
•
Mount the cooker hood onto the two screws and mark the bottom two screw positions.
•
Remove the hood and drill the bottom two screw holes and Insert the plastic wall plugs.
•
Mount the hood on the top screws, Insert the bottom screws and fully tighten all the screws.
CARBON FILTER INSTALLATION (OPTIONAL)
This model does not come with carbon filters, but they can be purchased and installed.
•
Remove the grease filter.
•
The charcoal filter is located at the end of the motor.
Turn the carbon filter until it is unscrewed.
•
Replace a new carbon filter and screw it in.
WARNING: The carbon filter cannot be washed or recycled. It should
be replaced after approximately 2-3 months of use.
Carbon Filter
Open
Close
10
Publicidad
