Items supplied
Tabletop Freezer
Ice cube mould
Operating instructions
Description of the appliance
1 "Super Freeze" control lamp (yellow)
2 Temperature control lamp (red)
3 Operational control lamp (green)
4 "Super Freeze" switch
5 Temperature regulator
6 Adjustable feet
7 Storage compartments
8 Freezer compartments
Setting the appliance up
Note
While setting the appliance up, and also later should
you want to relocate it, do not slope it by more than
45 °.
Ventilation
In order not to impede the heat exchange, and to
ensure high cooling efficiency with low power con-
sumption, a free space of 50 mm should remain
above the appliance. Should this not be possible,
then at least a space of 25 mm on each side of the
appliance.
Laying and connecting the power cable
Connect the appliance via the power cable with
a properly connected and earthed 230 V mains
power socket. Do not use extension cables or multi-
plug sockets. It must at all times be possible to dis-
connect the appliance from the mains power supply
by simply removing the plug from the mains power
socket. Route the power cable so that it does not
make contact with the compressor of the appliance.
This becomes hot during operation and could da-
mage the insulation of the cable. Also ensure that
the cable does not come under the adjustable feet 6
or is in any way clamped and, because of this, could
be damaged.
Protect against moisture and heat
Place the appliance in a dry and well ventilated
room. The appliance is not suitable for operation
outdoors. Protect the appliance from direct sunlight
and do not place it near sources of heat such as
stoves or radiators, etc.
Installation of the appliance
Ensure that the freezer is positioned horizontally on
a stable surface. It works properly only in this position.
Check that it is horizontal with a spirit level. To make
any corrections, you can screw the the adjustable
feet 6 in or out. All adjustable feet 6 must have solid
contact to the undersurface so that the appliance
stands firmly.
Attention!
To avoid the risk of fire, do not place electrical heaters
on the freezer. Also, do not place kettles or water
boilers on it, as overflowing boiling liquids could
damage the electrical insulation of the appliance.
- 32 -