Jata JVVP3046 Instrucciones De Uso página 8

• VERY IMPORTANT: Do not immerse the fan in water or any
other liquid.
• This appliance has been designed for domestic only. Don't
allow children play with the appliance. Keep the fan out of the
reach of children.
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always place it on a flat and stable surface.
• Do not use outdoors.
• Do not use it without the frontal grid correctly assembled.
• Do not put the fingers or other objects into the fan to prevent
the engine block.
• Manipulation or replacement of any component must be
performed by an authorized service centre.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
ASSEMBLING INSTRUCTIONS
• Unscrew the locking nut of the grill (7) by turning it anti-clockwise.
• Place the rear grid (4) into the motor shaft and fix it with the screw grid (7) by turning it clockwise.
• Place the blades (1) on the shaft and tighten the screw in the flat area for correct fixing.
• Place the front grille (5) and make sure all the stops are closed and the bottom is secured with the screw.
Assembly instructions for the foot
• Insert the extendable tube (9) into the base of the foot (11) and screw with the 4 screws and nuts included.
• Loosen the height fixing nut (10) and remove the extendable tube (9), insert the base trim. Insert the tube
and fix the height by tightening the fixing nut (10).
• Attach the body (6) to the extendable tube and secure it by tightening the side screw.
Mounting instructions for floor/wall base
• Fit the tubes of the floor base (12), as shown in the image, and fix them with the screws (d). Attach non-slip
feet (13) to base.
• Attach the body (6) to the base, placing the blades of the shaft (e) and fasten it with the screw of
the support (f).
• Note that the position of the body varies if you want to place the fan on the floor (Fig. 1) or on
the wall (Fig. 2) Fig. 1 Fig. 2
• For wall placement, place the wall brackets (g) with the screws (h) and dowels (i) and hang the base fan.
(Fig. 2).
INSTRUCTIONS OF USE
• Remember the fan always must be placed on a flat and stable surface.
• Plug the appliance into the mains.
• Move the air flow by turning the head or moving up and down the head till getting the desired position.
• Push the oscillation knob to active the oscillation function (8).
• To stop the swing pull up the swing knob.
• Turn the speed selector (2) to:
-Position 0 - Off.
-Position 1 - Minimum speed.
-Position 2 - Medium speed.
-Position 3 - Maximum Speedy.
8