Jata JVTE4235 Instrucciones De Uso página 12

• Make sure the appliance is not in direct contact with hot
surfaces or objects.
• Always place it on a flat and stable surface.
• Do not use outdoors or in any room with high humidity or
exposure to water.
• If the power cord or any other component is damaged, it must
be replaced by the manufacturer or by its after-sales service or
similar qualified personnel in order to avoid a danger.
ASSEMBLING INSTRUCTIONS
1. Make sure the place where the fan is going to be installed is wide enough, to improve the flow of air
through the room
2. To prevent the blades from colliding with any object, it is recommended to leave a minimum distance of
0.60 meters (x) on each side.
3. The fan must be installed in such a way that the blades are 2.3 meters from the ground (y).
4. The location chosen for its placement must be able to support a minimum of 45 kg in order to support the
weight of the fan.
5. Note: the fixing screws (11) (included) are designed to be used with the fan on a wooden ceiling. If the
installation is carried out on a different material (concrete, false ceiling, etc.) it is recommended to use the
appropriate fixing screws for that material (not included). Fig. 1
6. Unscrew the upper screw of the engine mount anchor, slide the plastic plunger down and remove the pin.
Fig. 4
7. Remove the retaining clip to extract the pin from the lower end of the engine support anchor (5)
8. Insert the roof trim (4) and the engine trim (6).
9. Next, pass the upper engine cables through the inside of the engine support anchor (5) to the other end.
Fig. 5
10. Insert the upper pin of the engine support anchor (5), moving the connection cables aside, and raise the
plunger to the end. Then tighten the screw to secure it securely. Fig. 7
11. Subsequently, insert the motor support anchor (5) into the upper motor anchor (7) and secure it by
inserting the pin with the retaining clip and tightening the screw. Fig. 6
12. To assemble the blades (1), remove the lower motor screws, each blade has two screws.
13. Place the blades (1) keeping in mind that its curve must face up and screw them firmly so that they do not
oscillate when they are in operation. Fig. 2
14. Then, place the LED light support (8). First, loosen the screws of the round anchor, located at the bottom
of the motor, pass the light cable through the hole and screw it.
15. Next, connect the LED lights (9) (Blue-Blue / Black-White)
16. The LED lights are attached to the support by magnets so they can be moved for placement. Fig. 3
17. Place the ceiling support plate (2) in the desired location, ensuring that the ceiling power cables are
centered to make the subsequent connection.
18. Make the holes in the ceiling, taking into account the previous indications about the types of surfaces, and
anchor the ceiling support frame (2). Fig. 8
19. Make sure that the electrical current is disconnected.
20. Place the semi-assembled fan by inserting the piston of the motor support anchor (5) into the ceiling
support frame (2) matching the groove of the piston with a small notch in the support frame. Fig. 9
21. Place the Receiver (3) on the ceiling support frame (2). Note that the wires from the receiver must be on
the side of the receiver where the power strip is located.
22. Then, make the connections according to the following diagram: Fig. 10
23. Unscrew the side screws of the roof trim (4).
24. Once connected, place the roof trim making it coincide with the holes of the support frame (2) by turning
and insert the screws.
24. Once located on the ceiling, place the ceiling lamp (10) making it rotate on the LED support (8). You can
now connect the electrical current. Fig. 11 y 12
26. The balancing kit (12) should only be used if there is considerable wobble in the fan after fully assembled:
12