Graco AFFIX I-SIZE R129 Manual Del Propietário página 7

Rotate the ISOFIX connectors
15
by 180 degrees, then press the
ISOFIX adjusting button to fold
the ISOFIX connectors.
! Pull the vehicle safety belt and
pass through the belt path 18
and then buckle it up. 18 -3
! Could also be installed by using
3-point belt only. 18 - 22
! Position shoulder belt through
the shoulder belt guide shown
in -1
18
! DO NOT position vehicle belt
over top of the armrests. It must
pass underneath the armrests.
-2
18
! The booster can not be used if
the vehicle safety belt buckle
(female buckle end) is too long
to anchor the booster securely.
-4
18
! After your child is placed in this
booster, the safety belt must
be used correctly, and ensure
that any lap strap is worn low
down, so that the pelvis is firmly
engaged. 18
! To ensure the correct head
support height is obtained, the
bottom of the headrest MUST
be even with the top of child's
shoulders as shown in
19
and the shoulder belt must be
positioned in the green zone as
shown in
20
! Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt.
! Make sure, that the shoulder belt
portion of the vehicle belt goes
,
straight through the shoulder
belt guide as shown in
! Tighten the vehicle belt by
pulling the shoulder strap until
all belt slack is removed.
! If the belt lays across child neck,
head or face, readjust head
support height.
! Any straps holding the booster
to the vehicle should be tight
and the straps should not be
twisted.
Use Cupholders
See image
23
Detach Soft Goods
See image
24
Open buttons and elastics on the
back of soft goods to remove it.
To refit the seat pad simply reverse
the steps above.
11
Care and
Maintenance
Please wash the seat cover and inner
padding with cold water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft
21
goods.
Do not use undiluted detergents,
gasoline or other organic solvent to
wash the child restraint. It may cause
damage to the child restraint.
Do not wring out the seat cover and
inner padding to dry. It may leave the
seat cover and inner padding with
wrinkles.
Please hang dry the seat cover and
inner padding in the shade.
Please remove the child restraint
from the vehicle seat if not in use for
a long period of time. Put the child
restraint in a cool, dry place where
your child cannot access it.
Do not tamper with the harness
connectors during cleaning.
gracobaby.eu
www.gracobaby.pl
12