Kicker PXIBT100.2 Manual Del Propietário página 5

Crossover Switches: Use the HI-PASS switches behind the protective rubber covering of the unit to set
the internal crossover. Choose a cutoff of 60Hz, 80Hz, 120Hz, or OFF depending on the confi guration of
switches 1 and 2. Never change the switches with the audio system on!
Playing Music: The PXIBT100.2 is designed to receive audio via Bluetooth transfer protocol, 3.5mm
auxiliary input, and USB input. The USB input supports MP3 and WMA fi le formats.
The unit will power up in Bluetooth pairing mode when used for the fi rst time. To re-enter pairing mode at
any time, press and hold the PLAY-PAUSE button until the Bluetooth LED fl ashes blue rapidly. To pair
with an audio device, enter pairing mode on the unit, then enter 'disovery mode' on your audio device.
Select 'KICKER PXIBT' on your audio device. The Bluetooth icon will be solid blue when connected and
ready to play. If the Bluetooth icon fl ashes blue slowly, the unit is paired with a device, but not connected.
Check your audio device if this occurs.
Use short presses on the POWER button to cycle between Bluetooth, AUX, and USB input modes.
The unit will remember the last input mode used when powered ON/OFF. You may press and hold the
POWER button to turn the unit ON/OFF, however it is recommended that you install a switch in-line with
the RED (+12V Ignition) power wire to mimic an accessory key switch. This will turn the unit ON/OFF with
the vehicle.
Changing Brightness: Press and hold the Track  button for 5 seconds. After the remote blinks three
times, the volume buttons will now control the remote LED brightness, from off (0) to full intensity (10).
After the desired brightness is set and no key presses are detected for 5 seconds, the remote will blink
three times and exit brightness mode. The volume buttons will now go back to controlling the volume
level.
Input Status LEDs:
B/T - Slow Flash - Paired; no connection
B/T - Rapid Flash - Pairing mode
B/T - Solid - Bluetooth Connected
Volume 
Brightness up
Volume 
Brightness down
NOTE: Bluetooth open environment range up to 30ft.
2016 PXiBT100.2 Rev G.indd 5 2016 PXiBT100.2 Rev G.indd 5
POWER OFF/ON - Use if there is no
Track 
switched ignition source in your vehicle.
Brightness Mode SELECT SOURCE - Bluetooth/AUX/USB
Track 
Short Press - PLAY-PAUSE
Press & Hold - PAIRING MODE
5
12/8/2015 11:35:29 AM 12/8/2015 11:35:29 AM