KNOVA KN SCM-07A Manual Del Usuario página 5

ASSEMBLY
To assemble the band saw:
1. With the help of an assistant, lift the band saw onto a
suitable support.
2. Attach the legs to the band saw with
the M8-1.25 x 25 hex bolts, 8mm flat washers,
8mm lock washers, and M8-1.25 hex nuts.
3. Attach the short brace to the legs with
the M6-1.0 x 16 carriage bolts, 6mm flat washers,
6mm lock washers and M6-1.0 hex nuts.
4. Lift the band saw onto floor,
attach the long brace
to legs with the M6-1.0 x 16
carriage bolts, 6mm flat
washers, 6mm lock washers
and M6-1.0 hex nuts.
5. Use the M6-1 x 12 hex bolts, M6-1 hex nuts, 6mm
6. Slide the shaft through the holes in the wheel
7. On the other side legs,
8. Check to see if
9. Remove the screws
Carriage
bolt
4
lock washers and 6mm flat washers to install
the wheel mounting bracket to legs
Cotter
pin
mounting bracket. Slide the wheels onto the shaft on
the outside of the mounting bracket, and secure
them with the cotter pins
insert the handle into
the pre-drilled holes
and secure it with
the cotter pins.
the bands saw is
relatively level,
then final tighten
all the nuts.
and washers from
band saw. Place
the belt house over
the motor and gear
shafts, and secure
it with the removed
screws and washers.
Cotter
pin