Publicidad
Idiomas disponibles
Idiomas disponibles
Rubber seal gaskets
Adjusting handle for
mixing valve
④
If the users want to realize a multi-way supply system, refer to the method shown in fig.5 for
connection of the pipelines.
Triple joint
Water pool
Please be sure to use the accessories provided by our company to install this electric
water heater. This electric water heater can not be hung on the support until it has been
confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from
the wall, resulting in damage of the heater, even serious accidents of injury. When
determining the locations of the bolt holes, it shall be ensured that there is a clearance
not less than 0.2m on the right side of the electric heater, to convenient the maintenance
of the heater, if necessary.
4. METHODS OF USING
●
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet valve.
The water heater gets filled with water. When water flows out of the outlet pipe it implies that the
heater has been filled fully with water, and the outlet valve can be closed.
Hot water outlet
Hot water
Hot water
outlet
Mixing valve
Cold water inlet
Pressure relief valve
Pressure release hole
Joint screw for cold water inlet
Cold water
inlet
NOTE
6
Power cord
Rubber seal gaskets
Power cord
Pressure relief valve
Water inlet valve
Shower nozzle
Water inlet valve
Running water pipe
(Fig.4)
(Fig.5)
Publicidad
