Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
WARNING:
Do not short battery termi-
nals by allowing a wrench o r any other object
to contact both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings, etco
Positive terminal
must be connected
first to
prevent sparking fro m accidental
ground ing,
1. Lift seat pan to raised position,
2.
Disconnect
BLACK
battery
cable
first
then
RED
battery
cable
and carefully
remove battery from tractor.
3o Install new battery with terminals
in same
position as old battery,
4.
First connect
RED battery cable to posi-
tive (+) terminal
with hex bolt and keps
nut as shown.
Tighten
securely°
Slide
terminal
cover over terminal
5. Connect
BLACK
grounding
cable
to
negative
(-) terminal with remaining
hex
bolt and keps nut. Tighten
securely°
Seat
Terminal
Keps
Cover
Nut
Hex
Bolt
(Red)
Cable
Negative (Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2.
Remove
bulb holder from the hole in the
backside
of the grill.
3.
Replace
bulb in holder and install bulb
holder securely
back into the hole in the
backside
of the grill°
4.
Close hood°
INTERLOCKS
AND RELAYS
Loose or damaged
wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring. See electricalwiring
diagram
in the Repair Parts manual.
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-
in fuse. The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD & GRILL ASSEMBLY
1,
Raise hood.
2o Unsnap
headlight
wire connector.
3, Stand in front of tractor° Grasp hood at
sides, tilt toward
engine and lift off of
tractor.
4. When replacing
hood, be sure to re-
connect
the headlight
wire connector.
__
Hood
_..._..__
!
Headlight Wire
Connector
ENGINE
TO ADJUST
THRO'T3rLE CONTROL
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check adjustment
as described
below before loosening
cable, If adjustment
is necessary,
see enginemanuaL
TO ADJUST
CHOKE
CONTROL
The
choke
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary.
If adjustment
is necessary,
see
engine manual,
TO ADJUST
CARBURETOR
Your carbure[or
has been preset at the factory
and adjustment
should
not be necessary.
However,
minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude or load. If the engine does
need adjustment,
see engine
manual°
27
Publicidad
