Create WARM SLIM 1500 Manual De Instrucciones página 9

4. Screw the two support brackets (A) (or one support bracket, depending on the model) to
the rear part of the heater with the four screws (E) (or two screws, depending on the model).
Note: The two brackets (A) are screwed to the holes located on the lower rear part of the
heater, at both ends.
5. Hang the heater on the two hooks (C) on the wall. Ensure that the heater is correctly se-
cured on both hooks.
6. When the heater is hung in place, make two marks on the wall where the two brackets (A)
will be fixed to ensure the heater is fixed to the wall.
7. Remove the heater and drill two 4 mm diameter holes with a minimum depth of 25 mm at
the two marks on the wall.
8. Insert the two plugs and secure with the two screws (B) to completely secure the heater
to the wall.
INSTALLI NG THE F E E T
1. Screw the two feet to the lower rear part of the heater with the four screws provided (F):
two screws per foot.
• Place the heater on flat stable surface
• Plug into any 220-240V, 50Hz, AC source, then turn on the switch at side, you will hear a
beep sound.
• Turn on the heater by pressing the power button " ", the LED will display room tempera-
ture, then use the touch controls or remote control to set the power, temperature and time.
• If the appliance is not used for a long time, switch it off with power switch and unplug the
item.
• Warning! Do not cover the product! Convector should not be placed under shower or in
swimming pool.
USE OF THE ITEM
F F
E NGLI SH
9