Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person is
recommended when assembling this
unit Take the unit out of its box and
make sure that all of the pieces are
there Fig.0:
(A) Main body; (B) Front stabiliser bar
with wheels; (C) Rear stabiliser bar;
(D) iPad support; (E) Handlebar; (F)
Saddle; (C05) Knob; (C42) Left pedal;
(C43) Right pedal; (C22) Knob; (A9)
Limit plate; (C36) Nut; (E08) Adapter;
(D26) Washer D6; (D22) Screw M8x25;
(D23) Screw M6x12; (D27) Washer D8;
(D24) Screw ST3.5x10; (D25) Washer
D8; Wrenches.
1.
Position the machine's rear stand
on the rear stabilizer bar (C), as
shown in Fig.1, insert the bolts (D22)
and the washers (D25), (D27) and
then tighten securely.
Position the front stabiliser bar with
wheels (B) with the wheels facing
forwards, as shown in Fig.1, insert the
bolts (D22) and the washers (D25),
(D27) and tighten securely.
Fit the knob (C05) of the handlebar
post.
2.- FITTING THE HANDLEBAR.-
First fix the iPad support (D) by
inserting the hooks (H) into the holes
(K), Fig.2. Fit the screws (D24).
Connect the monitor cable (E03) with
the handlebar post cable (E04), Fig.3.
Place the handlebar (E) on the
handlebar post (A02), Fig.3, tighten
with the screws (D23).
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Loosen the knob (C05) slightly by
turning it anticlockwise. Position the
handlebar
(E)
at
a
comfortable
distance to perform the exercise and
then tighten the knob (C05) firmly by
turning it clockwise, Fig.5.
Stay within the references.
3.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (C43), marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.3.
The left-hand pedal (C42), marked
with the letter (L), screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely, Fig.3.
4.- ATTACHING THE SADDLE.-
Place the seat (F) on the slider (A03)
of the seat post by placing the knob
(C29), the plate (A09) and tightening
the nut (C36), Fig.4.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob (C05) slightly
anticlockwise, move the saddle to a
position comfortable for doing exercise
and then tighten the adjustment knob
(C05) securely by turning it clockwise,
Fig.5.
Stay within the references.
HORIZONTAL
THE SADDLE.-
Loosen the knob (C22) slightly by
turning it anticlockwise, move the
13
by turning it
ADJUSTMENT
OF
Publicidad
