Operating Instructions - Truma Trumatic S 3002 P Instrucciones De Uso

Operating instructions

Always observe the operating instructions and "Impor-
tant operating notes" prior to starting! The vehicle owner
is responsible for correct operation of the appliance.
The installer or vehicle owner must affix the yellow sticker with
warning information en closed with the appliance to a place
in the vehicle where it is clearly visible to all users (e.g. on the
wardrobe door)! Ask Truma to send you a sticker if necessary.
Trumatic S 3002 (P) Heater
e
b
h
d
f
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Automatic ignition (Trumatic S 3002 P model) or
Dummy cover (Trumatic S 3002 model)
d = Automatic ignition device with battery compartment
(model Trumatic S 3002)
e = Remote ignition display (accessory)
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
In the case of left-handed installation, the parts are arranged
on the other side.
Trumatic S 5002 Heater
e
b
h
d
f
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Dummy cover or Integrated control panel
for second Trumavent fan TEB / TEN
d = Automatic ignition device with battery compartment
e = Remote ignition display (accessory)
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
10
a
c
g
c
a
g
In the case of left-handed installation, the parts are arranged
on the other side.
Trumatic S 5002 Heater and front case with
flame effect
The flame effect and the Trumatic S 5002 heater can started
up together or separately.
e
b
h
d
f
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Dummy cover or Integrated control panel
for second Trumavent fan TEB / TEN
d = Automatic ignition device with battery compartment
e = Control panel flame effect
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
In the case of left-handed installation, the parts are arranged
on the other side.
Taking into operation with the piezo
ignitor (Trumatic S 3002 P only)
1. Turn on gas cylinder and open quick-acting valve in the gas
supply line.
2. Turn control knob (a) to thermostat setting 1 – 10 and press
it down as far as the stop. At the same time keep operating
the piezo ignitor rapidly until the flame ignites.
3. Keep the control knob pressed down for a further 10 sec-
onds to allow the safety pilot to operate.
4. Observe through the in spection window for a further
10 seconds so as to check that the flame has not been ex-
tinguished due to air in the line (caused by a change of gas
cylinder).
Wait for 2 minutes before re-igniting, otherwise
risk of misfiring! This also applies if a working heater
goes out and has to be re-lit.
c
a
g
a