HTW -VM-35FT Manual De Usuario página 11

TABLE FAN HTW-VM-35FT
1. Logo ring
2. Front grille
3. Screw for grille
4. Nut for grille
5. Screw for logo ring
6. Blade nut
7. Fan blade
8. Grille nut
9. Back grille
10. Oscillating control
11. Motor
12. Neck
13. Foot rubber
14. Body
15. Power cord
16. Speed control
17. Base
Step 1:
• Insert the Fan Body assembly into the base.
• Putting the 4pcs of foot rubber provided into the hole under the base cover.
Step 2:
• Unscrew the the Grille nut clockwise and remove.
• Set the back grille in the proper position with the handle up.
• Screw on blade nut tightly to attach back grille.
• Discard plastic sleeve on motor shaft.
• Install the blade onto the shaft until the retaining pin fits into the notch on the blade.
• Fit the blade nut to the motor shaft counter clockwise (tighten by turning to the left)
• Use 1 screw to install the logo ring in the middle of front grille.
• Mount Front Grille onto back Grille by hanging the top hook clip of front grille over the top of the back
Grille. Close the clasps all around the grille. Finally fit the grille nut and screw through the hole in the
bottom edge of the front grille and tighten.
Step 3:
• Place your fan on a level and dry surface.
• Plug the power cord into AC220-240V wall outlets.
USER MANUAL
ASSEMBLY
11
