Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.6.3 Parameter settings or checking: P8/P9/P10/P11
7.6.3.1. Press
first and then press
or
to enter parameter checking.
7.6.3.2. Press
again and press
then press
to save the setting and exit.
7.7. Reset function：
Long press"
and
7.8.
7.8.1 It show current time or timer on/off if there is in parameter P4,P5,P6.
7.8.2 It show error code when there is troubleshooting in the heat pump.
Remark: it shows current time with below situation:
a、Compressor start within 10 minutes
b、Heat pump operation frequency change
c、During defrosting
d、Working mode is cooling mode
7.9.
7.9.1 Normally it show the temperature.
7.9.2 It show the parameter when there is parameter checking.
7.9.3 It show the parameter code when there is in P4, P5, P6.
7.
Start-up
7.
7.
Start-up
Start-up
and
or
" in 10 second to reset the data.
of
the
Heat
Pump
of
of
the
the
Heat
Heat
Pump
Pump
on the same time in 15 second, the screen flash and press
to set parameter if needed, and press
- 35 -
to confirm the setting
Publicidad
Capítulos
Tabla de contenido
