Jackery Explorer 1000 Manual De Usuario página 6

US
LCD Screen
•
Power Level Percentage
Check the battery level by pressing the display button before use. If battery is at a low level,
charge first.LCD screen flickers around 10 times when the battery capacity drains to 20% to 10%.
Power of Input Output (W)
Please ensure that power consumption is less than 1000W, then press the power
button. If the Jackery Explorer's total output exceeds 1000W, it will shut o .
Low & High Temperature Alarm
The E1000 can power your devices at temperatures ranging from -10°C~40°C.
If your working temperature is outside this range, the unit may stop working.
Other
•
How to reset the Explorer 1000
Please try to hold the display power button for 8s to reset the battery.
When should we need to reset the power station?
When the power station can't work properly, you can choose to reset the battery
to trouble shoot.
Fan Operating Principle
E1000 uses intelligent temperature control. When the AC is turned on, the fan does
not turn on.Only when the temperature rises to a certain degree then the fan starts to turn on.
Attention
•
Input Power
Output Power
If you operate the power station in improper way, there will be appearing symbols on LCD screen.
Battery has been drain out
It shows that the battery has been drain
out.Please kindly charge it to 100% and then
use it.A warming tip: It's suggested to
recharge the battery before the power drops
below 15%. Please don't drain out the battery.
High
Temperature
It shows that the battery is used in a high
or low temperature. Please charge, use
and store the E1000 within a ambient
temperature 0°C~40°C (32°F~104°F).
04
Low
Temperature
Battery was overcharged
It shows that the battery was
overcharged.Please try to hold the display
power button for 8s to reset the battery and
try to charge to see.
Over-loaded
It shows that the power station is
over-loaded, please kindly check the power
of your device and hold the display power
button for 8s to reset the battery and try to
charge to see.
Power Display