Contest VCOB-60DW Manual Del Usuario página 24

VCOB-DW - Dynamic white COB LED architectural projectors IP66
6.7 - VRDM-Split splitter :
The VRDM-Split is a DMX RDM 1xIN 2x OUT IP66 splitter. It reboosts the incoming DMX signal on two RDM-compatible DMX outputs. It has a
Hybrid Power/DMX input on which the DMX signal will be extracted in order to be divided into two separate isolated and protected lines.
The Hybrid input supply will be disconnected and a new Power IN supply will be injected on the two Hybrid outputs.
architectural-lighting.eu
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
+45°C
1m -20°C
DMX/POWER IN
DMX/POWER OUT
AC 100-240V 50/60Hz
MAX: 10A
FUSE: T3A/250V 120W
IN
OUT
D+ D- GND
DMX-IN
L
N
Disconnect
Power
Hybrid
POWER+ DMX IN
Hybrid
Power + DMX OUT1
VRDM-Split
D+ D- GND D+ D- GND
DMX-IN DMX-OUT1
L N L N
Disconnect Power Power OUT1
IN
OUT1
IN
Contest Architectural Lighting
VRDM-Split
D+ D- GND D+ D- GND
DMX-OUT1 DMX-OUT2
L N L N L N
Power OUT2
Power OUT1 Power INPUT
16A (3500W max)
Power + DMX OUT2
Contest Architectural Lighting
VRDM-Split
D+ D- GND
DMX-OUT2
L N L N
Power INPUT
Power OUT2
Power IN
OUT2
architectural-lighting.eu
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
+45°C
POWER IN 1m POWER OUT
-20°C
DMX IN DMX OUT
OUT
The Hybrid Power+DMX IN input on the left is used to recover the
DMX signal which will be filtered, divided and protected.
The power supply will be disconnected from the circuit via the
Disconnect Power connector.
The Power IN input on the right is used to supply the splitter and to
re-inject the supply into the outputs.
Outputs OUT1 and OUT2 therefore have a reboosted DMX signal
and power supply to start new lines.
Note :
In this case, the VRDM-Split is used in a Hybrid 1 x IN, 2 x OUT
configuration.
It is possible to use the VRDM-Split simply by entering with a DMX
Power IN
IN signal to 2 x DMX OUT and supplying the box with power IN
only.
It is also possible to mix the two combinations for more flexibility.
Hybrid
CAUTION !
The sum of the powers of the different lines must
not exceed the power of the Power input (3500W).
The power per line is limited to the characteristics
of each of the devices, see table in the section on
chaining of projectors.
architectural-lighting.eu
IN
Distributed by HITMUSIC SAS
FRANCE
MADE IN CHINA
+45°C
1m
-20°C
OUT
English
Page 9