Assembly; Caster/Caster Foot Assembly - RIDGID HD14000 Manual Del Usuario

ASSEMBLY

Caster/Caster Foot Assembly

NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of
Casters and Caster Feet.
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor. Insert the
stem of a Caster into socket of Caster
Foot.
3. Push on the Caster until the Caster ball
end snaps fully into the Socket and the
Caster swivel freely. Repeat for other
three Casters and Caster Feet.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other three Caster/
Caster Foot assemblies.
6. Turn the Dust Drum upright.
Post
Dust
Drum
Caster
Caster Stem
Caster Ball
Caster
Foot
Caster Foot
Caster Foot
Post Hole
Wet/Dry Vac Assembly:
Accessory Caddy Installation
1. Position the Accessory Caddy on the
back of the Dust Drum and align the
Locking Tabs.
2. Slide the Accessory Caddy Tabs into
the Dust Drum and push the Locking
Tabs in until you hear a click. Pull on
the Accessory Caddy to confirm it has
locked into place.
ASSEMBLED
Accessory
Caddy
6
Dust Drum
Locking
Tabs (2)