Publicidad
Idiomas disponibles
Idiomas disponibles
16.0 BWB INSTALLATION AND USE
16.1 SW-9012 BEHIND THE WEB BRACKET
The SW-9012 comes fully assembled and ready for installation. No tools are required for installation of the bracket onto
harness. Use the following instructions and Figure 11 to install the SW-9012 Behind the Web Bracket:
To Fasten To Harness:
1. Ensure that the curved portion of SW-9012 is in a downward orientation relative to the harness
(See Figure 11, Dwg. 1).
2. Simultaneously depress both locking buttons (A) and (B) (See Figure 11, Dwg. 2) and slide the bracket open
as indicated (See Figure 11, Dwg. 3).
3. With the bracket open, install dual leg retractables onto the bracket via the swivel tops of each. Swivels should
be hanging on the curved portion of bracket.
4. While pressing in on locking button (A) slide the bar behind both loops of webbing at dorsal D-ring until the bar
locks back into place.
5. Check the locking function of the bracket by attempting to slide the bracket open WITHOUT depressing locking
buttons (A) or (B). Bracket bar should not move and the bracket is now locked into place.
Bar assembly of bracket which inserts
behind webbing at dorsal D-ring
Dwg. 1
Diagram of SW-9012 in
opened configuration
Dwg. 3
FIGURE 11 - SW-9012 DUAL BRACKET INSTALLATION
Curved Portion of
SW-9012
V2.0 2022 Copyright Safewaze
Dwg. 2
Diagram of SW-9012 correctly
installed at Dorsal D-ring of harness
Dwg. 4
User Manual
Locking Button (B)
Locking Button (A)
10
Publicidad
