Publicidad
Idiomas disponibles
Idiomas disponibles
▶ Mounting and Removing Adapters
A.
Make sure the hex drive 1 is free. Pull
out any bit you might have used.
B.
Insert the hex shaft of an adapter into
the drive 1 and push the adapter until it
snaps in place. You may need to rotate
the adapter a little.
Fig. 3
B
14
▶ Using Right Angle Adapter
You can rotate the right angle adapter 13 to
any position around the axis of the tool in 9°
increments. See Fig. 5.
A.
Make sure the adapter is locked on the
tool. Pull the adapter 13 away from
the lock ring 14 approximately 3/16"
(5mm).
B.
Rotate the adapter 13 to a desired posi-
tion.
C.
Release the pull and let the adapter re-
turn to the locked position.
The right angle adapter's interface 13a is
identical to the interface of the power tool.
You can attach the other 3 adapters to it
the same way as the adapters are mounted
to the tool (See "Mounting and Removing
Adapters").
10
2610051918.indd 10
Assembly
1
A
C
C.
Lock the adapter in place by turning the
lock ring 14 in the direction shown until
it clicks (Fig. 3).
To remove any adapter, turn the lock ring 14
in the direction shown until it clicks. Pull the
adapter away from the tool (Fig. 4).
Fig. 4
14
Fig. 5
1 6
3 /
x .
m a
B
A
13a
13
m )
5 m
" (
14
C
6/11/19 2:10 PM
Publicidad
