Display Message Definitions; Debugging - Leviton Luma-Net LumaCAN Manual Del Usuario

10. DISPLAY MESSAGE DEFINITIONS
1. Bootloader XX.YY
2. Reading File
3. Checking File - validating file against flash.
4. Interactive
5. Rebooting
6. Launch App - starting application.
7. Burn Internal - reprogramming application.
8. Erase External - reprogramming application.
9. Burn External - reprogramming application.
10. Init Hardware - initializing hardware.
11. Init File System - initializing file system.
12. Init Ethernet - initializing Ethernet.
13. Waiting for DHCP
14. Configuring
15. Ready - startup sequence complete.
16. Start Fail
17. LN:xxx CAN:yyy - Luma-Net ® (LN) and LumaCAN TM (CAN) address.
18. No Config - no configuration stored.
19. WatchdogTimeout SSSS
20. Factory Defaults Total Clear - a "Total Clear" press sequence was detected and executed.
21. Factory Defaults Configuration - a "Configuration Clear" press sequence was detected and executed.
22. Rebooting...5
23. Boot Failed...Retrying

11. DEBUGGING

NOTE: Only a certified factory service technician should attempt to debug the device.
Page 12