Publicidad
Idiomas disponibles
Idiomas disponibles
▶ No further data transfer is possible.
Bluetooth can be deactivated if you are in a sensitive environment (e.g. a hospital) where use of
Bluetooth is prohibited.
To switch Bluetooth back on, remove and then re-insert the battery.
6.3
Switching the fastening tool on/off
6.3.1
Switching on the fastening tool
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body.
1. For magazine operation, load the magazine. → page 13
2. Insert the battery. → page 11
▶ Status indicator slow-flashes green.
If you continue to operate the fastening tool after battery performance drops, the fastening tool
will switch itself off automatically before damage to the battery cells occurs.
3. To switch the fastening tool on, press it against a suitable surface.
▶ Fastening tool is tensioned.
▶ The status indicator shows green.
6.3.2
Switching off the fastening tool
▶ Remove the battery. → page 11
▶ The spring mechanism audibly relieves its tension and the status indicator goes out.
After 6 minutes the fastening tool generates a motor sound as an alert indicating that the fastening
tool is about to switch off. The spring element is relieved. After another minute, the fastening tool
switches off automatically.
6.4
Driving a fastener
DANGER
Risk of injury The fastener guide jams.
▶ Before beginning the work, carry out a test by driving 2 fasteners into the material you are working on.
▶ Do not use the product if the fastener guide jams in the pressed-in condition: Section headed
"Troubleshooting". → page 16. Do not attempt to clear the blockage.
▶ Remove the battery and contact Hilti Service.
WARNING
Risk of injury by fasteners penetrating right through!
▶ Before driving fasteners, check to make sure that no one is present behind or below the object into which
the fastener is to be driven.
WARNING
Risk of injury by flying parts! When driving a fastener, there is a risk of injury to the body and eyes caused
by splintered fragments of the workpiece and by flying parts of the nail strip.
▶ Wear personal protective equipment and always wear eye protection and protective gloves. Other
persons in the vicinity must also wear eye protection and a hard hat.
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body.
14
English
6
2360185
*2360185*
Publicidad
