Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1a. Find back panel (1) and left side panel (4).
1b. Match up "A" label on back panel (1) with "A" label on left side panel (4)
and click together. Make sure the connection is flush across the entire
joint and there are no gaps between the two panels.
*
Assembly Tip – Make sure edges are aligned before clicking
together.
** Assembly Tip – To attach side panels you may find it easier to flip
the cabinet on its side(s). Be careful not to damage or scratch the
finished sides.
2a. Find top panel (2) and bottom panel (3).
2b. Match up "B" label on top panel (2) with "B" label on back panel (1)
and click together. Make sure there are no gaps between the three
panels.
2c. Match up "C" label on bottom panel (3) with "C" label on back
panel (1) and click together. Make sure there are no gaps between
the three panels.
3a. Find right side panel (5).
3b. Match up "D" label on right side panel (5) with "D" label on back
panel (1) and click together. Make sure there are no gaps on all
three connection sides.
1
Click
Align
4
2
B
B
1
2
4
Click
3
3
5
Click
D
2
1
4
ASSEMBLY INSTRUCTIONS
4a. Find door frame with door attached (6) .
4b. Match up "E" label on door frame (6) with "E" label on top panel (2) and
click together. Make sure there are no gaps on all four connection sides.
1
A
A
5. In & Out Adjustment: Turn screw (a) clockwise or counterclockwise.
Up & Down Adjustment: Turn screw (b) clockwise or counterclockwise.
Left & Right Adjustment: Turn screw (c) clockwise or counterclockwise.
C
C
Click
6. Insert shelf supports (8) into the desired holes inside each side
compartment. Make sure you place the four shelf supports at the
same level to level the shelf, then put in the adjustable shelf (7).
D
To remove the shelves, push the tabs on the shelf supports and lift
the shelf.
Click
Hardware Used
3
8
Shelf support
4
E
6
Click
E
2
5
4
5
c
6
Tab
7
7
x 8
7
8
5
Click
3
a
b
Publicidad
