Publicidad
Idiomas disponibles
Idiomas disponibles
• Keep toot wel! maintained
Follow
instructions
for lubricating
and changing
accessories
When
applicable,
keep tool
sharp
and clean
Inspect cord frequently
and have damaged
parts repaired
by a
Sears
service
center. Keep tool handle
and housing
clean, dry and free of
grease
and oil Never use strong
solvents
or petroleum-based
products
to clean tool
• Disconnect
tool when
not in use, before
servicing
and when loading
or changing
accessorie&
• Avoid unintentional
starting,
Never carry
tool with your finger on the switch
• Stay alert
Watch what you are doing
and use common
sense
Do not operate
tool when you are tired or under the
influence
of drugs, alcohol,
or
medication.
- Check damaged
parts
Berore using
tool, check that all parts will operate
correctly
and will perform
as designed.
Any damaged
parts should
be repaired
or replaced
by a Sears service
center
or other qualified
service
facility. Also,
check for misalignment,
binding,
and
broken
parts
Check that the switch
works
properly
and do not use the tool
if the switch does not turn the tool on
and off.
. Replacement
parts. When servicing,
use
only identical replacement
parts ordered
from a Sears service center or other
qualified
service facility
• Wear hearing protection
during extended
periods of operation.
,& WARNING:
Always wear eye
protection.
Any Power Tool can throw
foreign objects into the eyes which could
cause permanent
eye damage
ALWAYS
wear safety Goggles (not glasses) that
comply with ANSI safety standard Z87_ 1..
Everyday
glasses have only impact-resistant
lenses., ,they ARE NOT safety glasses.
Safety Goggles
are available at Sears.
NOTE:
Glasses
or goggles
not in
compliance
with ANSIZ87..1
could seriously
hurt you when they break.
,_k WARNING:
Do not aim nailer or shoot
brad nails at a person or animal. Released
brad nails can cause severe injuries.
,, Use only the brad nails indicated in this
manual, Use of accessories
that are not
designed
for this tool could result in
personal
injury andlor damage to the tool,
• Do not touch metal parts of tool during
operation,
Hold only plastic handle or
housing,
• Keep tacking speed at one brad nail every
two seconds.
• Nailer should be used only for the
purposes
outlined
in this manual, It is
designed
for use on wood
Do not use
on hard surfaces like rock, concrete,
etco
personal
injury or damage
to the tool
could result
• Special caution must be taken when
nailing for possible penetration
of nails
through
the wood into other objects° Use
correct size nails
• When
using this tool in high locations,
ALWAYS
make sure there is no one
below that could be injured
ALWAYS
be
sure you have a firm footing when using
this tool
• Always
hold too! firmly
• Never connect
tool to a DC power
source..
• Regular' cleaning,
inspection
and
maintenance
is necessary,
• During operation,
the nailer may feel
warm to the touch. This is normal.
However, if the nailer starts to feel hot,
discontinue
use until the unit cools down.
SAVE THESE
SAFETY
INSTRUCTIONS
3
Publicidad
