Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.
Pack Contents
The following is included:
•
POLAR Milk fridge
•
Shelf
•
Keys
•
Instruction Manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelve and interior with
soapy water then dry well.
4
DB109_ML_A5_v1_20230522.indb 4
Controller
•
The controller is located at the rear of the
appliance, covered with a removable cap. It has
been pre-set optimally by the manufacturer.
•
As needed, the controller can be adjusted
clockwise to make the appliance "Colder"
and counter-clockwise to make the appliance
"Warmer".
•
Nevertheless, we DO NOT recommend
customers to make any adjustment because
too cold setting may lead to freezing. Best
cooling performance can be achieved so long
as the unit is optimally filled and the internal
air circulation is not obstructed.
Internal light: Press the light switch on the
•
rear to turn the light on/off as required.
Note: If necessary, you can insert the pipe
from a coffee machine into the milk bottle
inside the fridge cabinet via the milk hole
on the side. Before insertion, please make
sure to remove the hole plug.
Refrigerating tips:
•
Condensation and ice will form with frequent
and prolonged opening of the doors.
•
Operating outside of the recommend
temperature range and placing next to a heat
source will also increase the amount of ice
and internal/external condensation. If external
condensation occurs wipe the surface down
with a cloth.
•
Excessive ice will result in longer running times
that will increase energy consumption and
increase the deterioration of components.
•
If the gasket or seal is damaged or deformed,
energy consumption will increase. To restore
efficiency, replace gasket.
2023/5/25 10:27:18
Publicidad
