GE G190 Manual Del Propietário página 7

GEAppliances.com
1 Tab \
3 \
//
/
4 OPTIONS
OFF
RINS__ FABRICSOFTENER
E×T. _ FABRICSOFTENER
SPl 2nd R_NSE & E×!ENOEO SP_N
_I_FABRICSOFT[NER
AUTOSOAK
+ EX!ENDEO SPiN AUTO + 2nd RINSE
SOAK
The Fabric Softener Dispenser
(on some models)
The fabric softener dispenser automatically releasesliquid fabric softener at the proper time during
the cycle.
Do not stop the washer or raise the lid during the first spin. This will cause the dispenser to
empty too soon.
Never pour fabric softener directly on clothes. This may cause stains on your clothing.
To use, follow these steps:
1] ift the tab on the fabric softener dispenser
top.
r2-] Measure out fabric softener into the cap
and pour the softener into the dispenser
top. The fabric softener will drain into the
receiving cup inside the dispenser. Use only
"Ultra" or concentrated fabric softeners.
I_] Pushdown on the tab to close the
dispenser top. Make sure the tab is pushed
down fully and snaps shut.
r_ Select FABRICSOFTENER from OPTIONS
on the control panel.
NOTE:Overfilling the dispenser will cause fabric
softener to drain out of the holes in the side of
the infusor when filling. Do not overfill.
NOTE: Do not use fabric softener dispensing
balls with this washer. They do not work
correctly in high efficiency washers.
Turning
Tabs
Turning
Cleaning the Fabric Softener Dispenser Ion some models)
The Fabric Softener Dispenser is self cleaning. This dispenser should not require regular cleaning
like standard fabric softener dispensers.Wipe down exterior surfaces of the dispenser as needed. If
cleaning of the internal dispenser components is needed, follow these steps after the wash cycle is
complete:
r_ Lift the dispenser top tab and turn the top
counterclockwise using the 2 turning tabs
shown. Lift the dispenser out of the infusor.
@
Clean out any buildup from inside the
infusor with a soft cloth or toothbrush.
Ensurethe three rectangular holes in the
bottom that allow the fabric softener to
drain are not blocked.
[_] Placethe dispenser assembly into the
infusor. Turn the top clockwise using the 2
turning tubs shown. Push down on the tub
to close the dispenser top. Make sure the
tab is pushed down fully and snaps shut.
%
@
Gently pull the cap away from the
dispenser cup to separate.
Wipe surfaces with a soft cloth or soak the
parts in a solution of i gallon warm water,
!/4 cup liquid detergent and ! cup bleach.
Ensurethe small hole in the top surface of
the cap and its associated tube are not
obstructed.
Reassemblethe dispenser cup and cap by
snapping them together.