Machine Operation (Scrubbing/Drying) - Clarke Vantage 17 B Instrucciones De Uso

Squeegee lifting
Lift the squeegee as indicated below:
1. Grasp the handlebar (2), lower it until the rear wheel (7)
touches the floor (A, Fig. 3) then engage the squeegee in
lifted position (B).

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
3. If necessary, adjust the solution quantity by using the push-button (65).
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the push-buttons (61).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-buttons (61).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Clarke suggests to go near the walls with the right side of
the machine as shown in figure 4.
CAUTION!
In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from turning, or to
excessively aggressive floors/brushes, the safety system stops the brush/pad-holder after about one minute of
continuous overload.
The overload is shown by the three battery LEDs (64) flashing simultaneously.
To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the switch
(62) to "0". Start the machine by turning the switch (62) to "I".
A A
INSTRUCTIONS FOR USE
Figure 4
9099650000 - VANTAGE 17 B
ENGLISH
clik
A
B
Figure 3
B
P100642
P100643
15