RADIO OPERATION
Cc
= Manual! tuning
1 Set the POWER switch to ON.
2 Press the TUNER button.
3 Select the desired frequency band. (FM ST, FM, MW or LW).
@ Set the BAND SELECTOR switch to FM ST for FM stereo; if
sound is poor, set the BAND SELECTOR switch to FM.
@ The
FM
STEREO
indicator
lights UR when
an FM
stereo
broadcast is received.
@ Please note that when the unit is being tuned in the FM ST
position,
interim-station-noise
as well as weak stations are
suppressed.
Only in the FM position, can weak
and noisy
stations be received.
4 Use the TUNING (UP or DOWN) button to tune in the desired
station. Holding it down for more than 0.5 sec. will cause the
frequency to change until the button is released.
5 To switch the unit off after use, set the POWER switch to O
STAND-BY.
Note:
Memory
recalls last station received
even
after changing the
BAND
SELECTOR
switch or setting the POWER
switch to ©
STAND-BY with the batteries installed in the unit.
@ Auto tuning
1 Perform steps 1 - 3 of the "Manual tuning" section.
2 Press the AUTO SCAN switch, and the AUTO indicator on: the
display will light up.
3 Press the TUNING (UP or DOWN) button to tune in a station.
The tuning stops automatically when a station is received.
4 Repeat the step 3 until you find the desired station.
@ To stop the auto scanning at any time, press the AUTO SCAN
switch again.