Publicidad
Idiomas disponibles
Idiomas disponibles
4. Replace the upper hinge protector (left and right). Replace the cover of the refrigerator's
lower screw hole. Replace the door screw hole cover (Fig. 6).
4. OPERATION
-
Use the appliance in accordance with the following control instructions. Figure 7 shows the
control panel icons and their corresponding functions.
-
For optimal food preservation, it is recommended to set the refrigerator temperature to 4°C
during the first use. If you wish to change the temperature, follow the instructions below:
Warning: when a temperature is set, this is an average temperature for the entire refrigerator,
the temperatures inside each compartment may vary from the temperature shown on the
control panel display, depending on how much food you store and where you place it. A high or
low ambient temperature can also affect the actual temperature inside the appliance.
1. Switch-on
-
Press and hold the "POWER"
-
When the refrigerator is switched on, the display will show "- -". If no button has been
pressed, the display will turn off after approximately 1 minute.
-
If you want to deactivate the power-on function, make sure that the control panel is
illuminated. If not, you can press any button to turn it on.
-
IMPORTANT! If the refrigerator is switched on but the display shows "- -", the appliance will
stop cooling.
-
If you are not going to use the device for a long period of time, disconnect it from the mains.
2. Fast Cooling function
-
This function allows food to be cooled more quickly and kept cold for a longer period of
time. During this process, vitamins and nutrients are locked in the fresh food, making it
last longer.
-
Press the button
display will show 2ºC .
-
The Fast Cooling function will automatically switch off after 6 hours.
-
When the Fast Cooling function is activated, you can deactivate it by pressing the button
again
, the temperature setting of the cooler will return to its previous state.
3. Temperature
Press the button
control display will show the corresponding figures according to the following sequence:
button for 3 seconds to turn the device on or off.
to activate the Fast Cooling function. The light will illuminate and the
to set the chiller temperature between 2°C and 8°C as required, and the
BOLERO COOLMARKET TT BI 138 E
ENGLISH
53
Publicidad
