Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
By combined actions of ROTATION and HAMMER
Boring holes in hard materials (concrete, brick, tiles, etc.)
By ROTATIONAL action:
Boring holes in steel, wood and plastic.
REMOVAL AND INSTALLATION METHOD OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latches to remove the battery (see Figs. 3 and
4).
2. Battery installation
Insert the battery aligning both guide rail of battery and body. Make sure the battery is
fixed firmly. (see Fig. 4)
Latch
Guide Rail of Battery
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
14
Battery
Fig. 3
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn out.
Handle
Pull Out
Fig. 4
Guide Rail of
Body
Insert
Publicidad
Tabla de contenido
