Publicidad
Idiomas disponibles
Idiomas disponibles
Engine
Clutchinc
Center
Jan
Keeper
Stationary Idler
Transaxle
TRANSAXLE
GEAR SHIFT
LEVER
NEU-
TRAL
ADJUSTMENT
The transaxte
should
be in neutral
when
the gear shift lever is in neutral
(N) (lock
gate) position.
The adjustment
is preset
at the factory;
however,
if adjustment
is
needed,
proceed
as follows:
1. Make sure transaxle
is in neutral
(N).
NOTE: When
the tractor
rear wheels
move
freely, the transaxle
is in neutral.
2.
Loosen
adjustment
bolt in front of the
right rear wheel
3.
Position
the gear shift lever )n the neu-
tral (N) position.
4. Tighten
adjustment
bolt securely.
NOTE:
if additional
clearance
is needed
to get to adjustment
bolt, move mower
deck height to the lowest
position.
Gearshiff_e.v.e r_
Neutral Lock Gate
Adjustment Bolt
TO ADJUST
STEERING
WHEEL
ALIGN-
MENT
If steering
wheel crossbars
are not
horizontal
(left to right) when wheels
are
positioned
straight
forward,
remove
steer-
ing wheel and reassemble
with crossbars
horizontal,
Tighten
securely.
FRONT WHEELTOE-IN/CAMBER
The front wheel toe4n and camber are not
adjustable on your tractor, If damage has
occurred to affect the front wheel toe-in or
camber, contact a Sears or other qualified
service center,
TO REMOVE
WHEEL
FOR REPAIRS
1.
Block up axle securely,
2.
Remove
axle cover, retaining
ring and
washers
to allow wheel
removal
(rear
wheels
have a square
key-
Do not
lose),
3.
Repair
tire and reassemble.
NOTE; On rear wheels
only:
align
grooves
in rear wheel hub and axle.
Insert
square
key,
4.
Replace
washers
and snap retaining
ring securely
in axle groove.
5.
Replace
axle cover°
NOTE;
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant
from Sears° Tire sealant
also prevents
tire dry rot and corrosion,
Washers
Retaining
Ring,
Axle
Cover
Square Key
(Rear Wheel Only)
TO START
ENGINE
WITH A WEAK
BAT-
TERY
_bWARNING:
Lead-acid
batteries
gen-
erate explosive
gases.
Keep sparks,
flame
and smoking
materials
away from bat-
teries.
Always
wear eye protection
when
around
batteries.
If your battery
is too weak to start the
engine,
it should
be recharged.
(See "BAT-
TERY"
in the MAINTENANCE
section
of
this manual).
If "jumper
cables" are used for emergency
starting,
follow this procedure:
IMPORTANT:
Your tractor
is equipped
with a 12 volt system. The other vehicle
must also be a 12 volt system,
Do not use
your tractor battery
to start other vehicles.
TO ATTACH JUMPER
CABLES
-
1, Connect
one end of the RED cabb
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking care not to short
against
tractor
chassis.
2_ Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3. Connect
the other end of the BLACK
cable (D) to good chassis
ground,
away from fuel tank and battery,
25
Publicidad
