Tennant T681 Manual De Instrucciones página 17

Battery Charger Settings
! ATTENTION: where machines are shipped without
batteries, the machine and the battery charger
are factory set for WET batteries as the default
type of battery, the battery charger setting MUST
be changed as described below. Failure to observe
these instructions could result in damage to the
battery. Depending on the type of battery selected
(wet lead-acid or sealed gel / AGM), the battery
parameters of the machine MUST be adjusted if
the section "Batteries".
SW1 SW2
DP1 DP2 DP1 CHARGING CURVE
OFF OFF OFF IUIa-ACD for Generic Wet batteries
OFF OFF ON IUIa/O-ACD for Generic Wet batteries
OFF ON OFF IUIa-ACD for Trojan Wet batteries
OFF ON ON IUUO-GEL for Gel and AGM batteries
ON OFF OFF IUIa-GEL Exide Sonnenschin batteries
ON OFF ON IUIa-AGM for Discover AGM batteries
ON ON OFF IUIa-GEL for Trojan GEL batteries
ON ON ON IUIa (SO) GEL
SW2
DP2
ON TCL ENABLED
OFF TCL DISABLE
SW1
DP1 DP2
OFF OFF
ON ON
Fitting the squeegee
! ATTENTION: before carrying out the operations
- Connect the suction hose to the squeegee,
bending it to the position as illustrated.
- Loosen the two knobs.
- Locate the two threaded pins in the slots on the
support.
- Tighten the two knobs.
The position of the squeegee is factory-set. Should the
squeegee blade require adjustment, refer to the section
"Squeegee adjustment".
DEFAULT SETTING
DEFAULT SETTING
SW2
DP1 DP2
OFF OFF
ON ON ON
Squeegee adjustment
! ATTENTION: before carrying out the operations
drying. With time, and the constant wiping action, the edge
a new blade is required. The state of wear should be
checked frequently.
To ensure faultless drying, the squeegee must be adjusted
as illustrated, in such a way that the edge of the rear blade
at all points along its length. The angle of the blade during
operation can be adjusted by regulating the height of the
two wheels positioned in front of/behind the squeegee.
EN 17