Publicidad
Idiomas disponibles
Idiomas disponibles
EN
English
2. Not coold enough
3.
Auto
heating mode.
4. Noisy
5. E1 Code
6. E2 Code
7. E3 Code
TECHNICAL SPECIFICATIONS
220-240V ~ 50Hz 785W
This product complies with directives 2014/30/EU EMC, 2014/35/EU LVD,
2011/65/EU & 2015/863/EU ROHS.
PRODUCT RECYCLING – ENVIROMENT
Do not throw this product in the trash at the end of its useful life. Take it to a
waste collection point, designated for this purpose (subject to the 2012/19/
EU WEEE directive)
14
- The doors or windows are
not closed.
- There are heat sources
inside the room.
- Exhaust air hose is not
connected or blocked.
- Temperature setting is
too high.
- Air inlet is blocked.
Power-Off
in
- Heating protection, when
the temperature at the
air outlet exceeds 70ºC,
the unit will power off
automatically.
- The ground is not level or
not flat enough.
- The sound comes from the
flowing of the refrigerant
inside the air conditioner.
Room temperature sensor
failed
Evaporator
failed
Water tank full
Make sure all the windows
and doors are closed.
Remove the heat sources if
possible.
Connect
exhaust air hose.
Reset the temperature.
Restart the unit at enough
lower room temperature.
Place the unit on a flat, level
ground if possible.
It is normal.
Replace room temperature
sensor (the unit can also
work without replacement.)
coil
sensor
Replace
sensor.
Please empty the water
tank.
or
clean
the
evaporator
coil
Publicidad
