Publicidad
Idiomas disponibles
Idiomas disponibles
contact with a wet surface or is operating in a damp environment. Water getting into the
device increases the risk of damage to the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cable only for its designated use. Never use it to carry the device or to pull the plug
out of a socket. Keep the cable away from heat sources, oil, sharp edges or moving parts.
Damaged or tangled cables increase the risk of electric shock.
e) If working with the device outdoors, make sure to use an extension cord suitable for outdoor
use. Using an extension cord suitable for outdoor use reduces the risk of electric shock.
f) If using the device in a damp environment cannot be avoided, a residual current device (RCD)
should be applied. The use of an RCD reduces the risk of electric shock.
g) Do not use the device if the power cord is damaged or shows obvious signs of wear. A
damaged power cord should be replaced by a qualified electrician or the manufacturer's
service centre.
h) To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do
not use the device on wet surfaces.
2.2.
Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to
accidents. Try to think ahead, observe what is going on and use common sense when
working with the device.
b) Do not use the device in a potentially explosive environment, for example in the presence of
flammable liquids, gases or dust. The device generates sparks which may ignite dust or
fumes.
c) If there are any doubts as to the correct operation of the device, contact the manufacturer's
support service.
d) Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
e) In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one intended for use
on live electrical devices) to put it out.
f) Children or unauthorised persons are forbidden to enter a work station. (A distraction may
result in loss of control over the device).
g) Use the device in a well-ventilated space.
h) The device produces dust and debris during operation. It is important to protect bystanders
from their harmful effects.
i)
Regularly inspect the condition of the safety labels. If the labels are illegible, they must be
replaced.
j)
Please keep this manual available for future reference. If this device is passed on to a third
party, the manual must be passed on with it.
k) Keep packaging elements and small assembly parts in a place not available to children.
l)
Keep the device away from children and animals.
m) If this device is used together with another equipment, the remaining instructions for use
shall also be followed.
n) Pay attention to the conditions of working area. Do not expose the device to rain or use it in
wet places. Working area should be properly protected, especially checked for the presence
of explosive and flammable liquids and gases (sprays, paints, gasoline, solvents, adhesives),
which may become the cause of fire or explosion when combined with sparks created by the
device. The device must not come in contact with high-voltage lines, gas/water piping, etc. In
EN
Publicidad
