Publicidad
Idiomas disponibles
Idiomas disponibles
Chips can't be flushed out of the
hole
Water jacket is
The seal of skeleton is worn out Change the seal
leaking
3.7.
Maintenance Guide
Safety precaution: Always ensure the device is unplugged from the power source before starting any
maintenance or repair work. This is crucial to prevent any accidental start-up and to ensure your
safety.
Cleaning the machine:
Use a dry or slightly damp cloth to clean the machine. Avoid using water jets as they can
•
introduce moisture into sensitive areas like the motor and switch box.
Keep the ventilation slots clear to prevent the motor from overheating.
•
Regularly clean and lubricate the core bit thread to ensure smooth operation.
•
Inspect all screws periodically and tighten them as necessary to maintain the integrity of the
•
machine.
Professional repairs: Only qualified personnel should perform repairs on your tool, and it's important
to use original spare parts. This ensures the safety and longevity of your machine and prevents
potential harm.
Carbon brush maintenance: After approximately 300 hours of use, check the carbon brushes for
wear. If they are worn out, they need to be replaced by an electrical specialist. This is part of
maintaining the motor's efficiency and reliability.
EN
Enhance water pressure, pull out the drill bit, clean
the hole
Publicidad
