YATO YT-85271 Manual Original página 14

EN
Maintenance and storage
Keep all nuts, bolts and screws in good condition to ensure safe tool operation.
In the case of multi-blade tools, be careful, as rotation of one cutting element may cause
rotation of other blades.
Use caution when adjusting the tool to avoid fi ngers getting between the tool's moving blades
and fi xed parts.
Always leave the tool to cool down before the next start-up, or before storing in a closed
space.
Be careful when performing any work on the blades, even when the drive is switched off
as the blades can still rotate. Always wait for the blades to come to a complete stop before
proceeding with any activities.
Replace worn-out or damaged parts to ensure safety of operation. Use original spare parts
and equipment only.
Risks related to noise and vibrations
The tool is designed to reduce the risk of exposing the user to noise and vibration as much
as possible. However, it is not possible to completely eliminate these hazards. Additionally,
people in the vicinity of the operating tool are also exposed to noise hazards.
However, the risks associated with the above-mentioned hazards can be reduced by observ-
ing the following guidelines:
- the product should be used in accordance with its intended use, described in the instruc-
tions manual;
- make sure that the tool is in good condition and is regularly maintained;
- use proper and well-sharpened cutting tools;
- use a fi rm grip on the product handle;
- plan work so that frequent breaks can be incorporated.
Residual risks
Even if all safety precautions are followed during operation, the potential risk of injury re-
mains. The following risks remain in relation to the design of the product.
Vibration-related injuries caused by prolonged operation of the tool, incorrect manner of
work, or work with an improperly maintained tool.
Injuries caused by an unexpected impact from hidden, ejected objects.
PRODUCT OPERATION
Preparing for operation
Unpack the product by removing all packaging components. It is recommended to retain the packaging, which can be of use when
transporting or storing the product.
Check that no part of the product has been damaged during transport. In case of damage detection, such as cracks or deforma-
tions, it will disqualify the product from further use until it is repaired or damaged components are replaced.
Use personal protective equipment such as protective gloves, eye protection, and protective clothing during assembly.
Caution! Before performing the product assembly, make sure that it is disconnected from the power supply. The battery
must be disconnected from the device.
O R I G I N A L I N S T R U C T I O N S
14