YATO YT-85271 Manual Original página 16

EN
Caution! Make sure that the product is disconnected from the power supply before starting any maintenance works. The
battery must be disconnected from the device.
Always wear protective gloves during all maintenance works.
If the maintenance procedure is not contained in the instructions manual, it means that it should be performed at an authorised
service centre.
Clean the product immediately after each use. The soil which remains on the blades will be the easiest to remove before it dries.
Soil residues should be removed from the blades with a soft brush or a painting brush with plastic bristles, or with a cloth. Clean
the ventilation openings to ensure that they are clear.
Dirt that is diffi cult to remove can be cleaned with an air jet with a pressure of up to 0.3 MPa.
Never use chemicals, alkaloids, abrasives, or aggressive detergents to clean the product. The product cannot be cleaned with a
water jet or by immersion in water.
Check for wear and damage to the blades. If excessive wear or damage is observed, replace the blade with a new one. The
blades will lose the paint coating during operation. This is a normal phenomenon and does not indicate damage to the blades.
Lack of paint coating, however, makes the blades more susceptible to corrosion. Therefore, each time after cleaning, they should
be covered with a thin layer of anti-corrosion agent or a thin layer of light mechanical oil. Before starting work, the blades must be
cleaned of any residual material to prevent the material from penetrating the soil.
Always replace the blades with the original ones, identical to the ones installed in the cultivator at the factory. Only the use of
original spare parts can maintain product safety. The blade should be replaced by an experienced user. To do this, contact an
authorised service centre of the manufacturer.
The blades should be replaced every two years or after every 50 hours of operation.
STORAGE AND TRANSPORT
Caution! Always disconnect the product from the power supply before storing or transporting it by removing the battery
from the socket. Clean according to the instructions.
Store in the dark, dry, frost-free, and well-ventilated areas. The place of storage should protect the tool from access by children.
The product should be stored at a temperature between 10°C and 30°C. It is recommended that the product is stored in its original
packaging or another packaging that protects it from dust. Keep the tool out of reach of unauthorised persons, especially children.
Make sure that the machine is out of the reach of unauthorised persons, especially children, also during operation.
Transport the product by carrying it by the handles. Transport it in such a position that the blades do not come into contact with
the ground. Protect the product from impacts and strong vibrations during transport. Secure the product against slipping or tipping
over during transport.
O R I G I N A L I N S T R U C T I O N S
16