Remote Control Unit Preparation
Battery Installation
4U . „
...
Lithium battery
O
Remove the battery holder.
(included)
Pull the battery holder by the position B while push-
v
'
ing position A in the direction indicated by the arrow.
ac Sl e
© Install the battery on the battery holder.
rf"}
Set a new battery properly with its "+" side facing up
/
as shown in the figure.
nV
4
© Insert the battery holder.
Position B
Push the battery holder back into its original position.
Battery Notes
Remove and dispose of an old battery immediately.
Battery holder
Position A
Battery Information:
• Battery type: Panasonic lithium battery (CR2025) (included)
• Battery life:
Approximately 6 months with normal use (at room temperature)
r
~— -"-
Caution:
• Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
s.___
• Do not disassemble or short the battery. Do not throw a battery into a fire.
• Keep batteries away from children to avoid the risk of accidents.
• Be careful to observe proper local disposal rules when you dispose of batteries.
Back side
Position B
Battery holder
Position A
Control Reference Guide
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
Point the remote control unit at the main unit's sensor (REMOTE).-^
Power button (PWR)
-
(=> page 10)
Mode (source) button (MODE)
{=> pages 12,14)
Band button (BAND)
(o page 12)
Note:
• Disc up button (DISC UP)
cannot be used in this
model.
Hsl
MODE
^
«nn 4SWl4
( ^
ii_it
C-)
Mute button (MUTE)
(■=* page 10)
Volume control buttons (VOL, a. v)
(■=» page 10)
Tune/track selection and search buttons
(TUNE/TRACK, ◄◄ ►►/< »
(«=> pages 12,15)