Publicidad
Idiomas disponibles
Idiomas disponibles
□ Installation Procedures
First complete the electrical connections, and
then check them for correctness. (*=> page 28)
Lock lever (*) -
Power connector-
insert mounting collar 0 into the dashboard, and
bend the mounting tabs out with a screwdriver.
Make sure that the lock lever
{■&)
is flush with the
mounting collar © (not projecting outward).
Lock lever
0
T
0
securely install the unit, fully bend a num-
1
ber of the tabs so that there is no rattling,
o Be sure to fasten the unit securely when join¬
ing it with the mounting collar ©.
(a) Using the rear support strap ®
Fire wall of car
~ Mounting tabs
Mounting bolt (5 mm0)
'v
Secure the rear of the unit.
After fixing mounting bolt (D and power connector
(D,
fix the rear of the unit to the car body by either
method (a) or (b) shown below.
Insert trim plate ®.
®
After
installation,
re-
connect the negative ©
l
rr7~
battery terminal.
@ Tapping screw
(5 mm0x16 mm)
/
3 mm
4>
_
© Hex. nut
"j
8
(5 mm0)
j/<® Rear support
strap_
'""x © Mounting bolt
N_(5 mm0)
0 Mounting collar
(b) Using the rubber cushion (option)
Rear support bracket
Rubber cushion (option)
(provided on the car)
V.
© Mounting bolt
X_(5 mm<ft)
0 Mounting collar
®Q<IlFSQeQ!OI?OQEffi
Publicidad
