RIDGID R8604301 Manual Del Operador página 6

ASSEMBLY
UNPACKING
This product requires assembly.
„ Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
„ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
„ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
„ If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
blower. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the tool when assembling parts.
ASSEMBLING THE BLOWER TUBE
See Figure 2, page 10.
„ With the latch slot facing up, slide the blower tube over
the outlet on the blower housing.
„ Press down on the tab on the blower housing outlet.
„ Push tube on the blower housing outlet until tab locks
into place through the slot in the blower tube.
„ To remove the blower tube, push tab down and slide
tube off.
6 — English