Publicidad
Idiomas disponibles
Idiomas disponibles
Channel 3 Control
3 position switch used for optional
parts.
If using HPI LED adaptor #160581,
CH3 Switch is used for the LED ON-
OFF Functions.
Installing the Transmitter Batteries
Turning on the power
Turn on transmitter fi rst and then turn on receiver.
Hold down the transmitter switch and the LED battery
indicator will light up Red. An audible beep will sound.
Turn on the receiver.
If the transmitter is left on without input for more than 5
minutes the LED will Flash Green and an audible beep will
sound to remind the user to turn off the set.
Turning off the power
Turn off receiver fi rst and then turn off transmitter.
If you switch off the transmitter fi rst before the R/C car, you may lose control of the R/C car.
•
Turn off the receiver switch.
•
Hold down the transmitter switch. An audible beep will sound.
•
Disconnect the battery connector from the speed control connector.
Binding the Transmitter and Receiver
You may need to setup your transmitter to 'bind' with the receiver if you change to a new receiver or for any reason
lose signal.
•
Place the transmitter and the receiver close to each other (within one meter).
•
Turn ON the transmitter by holding down the power switch.
•
Press and hold the receiver setup button, then turn the power switch to the ON position.
•
The receiver LED will fl ash quickly. Release the setup button after 1 second.
•
Press and hold the binding button on the transmitter for 1 second until the LED on the
receiver is continuously lit.
Fail Safe Setup
Caution
Any new binding of transmitter & receiver will clear the pre-set fail safe.
•
With the transmitter and car switched on, press the setup button on the receiver then release. LED will fl ash.
Electric setup
•
Leave throttle trigger in neutral position, and press the setup button. The LED will fl ash quickly. Once the
receiver LED remains lit, then release the setup button on the receiver.
Nitro setup
•
Hold full brake on the transmitter, and press the setup button. The LED will fl ash quickly. Release full brake on
the transmitter once the receiver LED remains lit, then release the setup button on the receiver.
Open the battery holding
tray to expose the empty
battery slots.
Insert 4 AA batteries
into the marked spaces.
Please note the correct
direction of the batteries
Channel 4 Control
100 position range used for optional
parts. Single press will change the
position by 1. Hold down will change
the position by 10. The central
position is denoted with a double
beep sound.
+ve -ve
Power LED
3
Incorrect battery insertion
could damage the transmitter
2.4Ghz technology has done
away with the need for long
extendable aerials. The Aerial
on your transmitter is located
internally
The Red LED will show if the
installed AA batteries have
suffi cient charge.
The Red LED will fl ash and
there will be an audible beep if
the batteries need replacing.
Publicidad
