Magmaweld COMPACT ECO Serie Manual De Instrucciones página 23

COMPACT ECO SERIE
4 TRIGGER MODE : When the torch trigger is pressed and released once, welding starts
and there is no need to hold it pressed until the welding ends. Pressing and releasing the
trigger again will end the welding process.
• Press and hold the torch trigger.
Welding Start;
• Shielding gas flow starts as long as the pre-gas period.
• At the end of the pre-gas period, the wire feed motor runs at a slow speed.
• Welding current increases when the workpiece is reached.
• Release the pressed torch trigger and the welding will continue.
• Release the pressed torch trigger.
Welding Termination;
• The wire feed motor will stop.
• The arc extinguishes after the set burn-back time.
• The process ends after the final gas period.
Welding starts as soon as the trigger is pressed and welding continues for the specified
Spot (Method) Mode
on-time period and stands by during of off-time; the process continues as long as the
button is pressed. Welding will also be terminated when the trigger is released. If spot
is selected in the Trigger mode, the On and Off times as well as the welding and standby
times are determined.
www.magmaweld.com
It should be preferred when the same welding seam and penetration are desired
every time. The lengths of the welds made in Spot (Method) mode will be equal.
Operation
PrG : Initial Gas Time
: Welding Current
PoG : Final Gas Time
I
USER MANUAL
23
EN