Publicidad
Idiomas disponibles
Idiomas disponibles
The burner does not
ignite with a match.
There is an irregular
flame pattern, the flame
does not run the entire
length of the burner.
The flame strikes out.
There is a persistent
grease fire.
There is a flame backlash
(fire in the burners).
There is little or no gas
supply.
The clutch and regulator
are not fully connected.
Gas supply is obstructed.
The burners are clogged
or blocked.
The burners are clogged
or blocked.
The new burners may
contain residual oils.
There is food residue,
grease or cooking salt on
the burners.
The valve is misaligned
with the injector venturi.
High winds or gusts of
wind are present.
There is little to no gas
supply.
Grease is stuck due to
grease buildup around
the burner system.
The burners and/or
burner tubes are blocked.
English
Check that the gas
cylinder is empty. If it is
empty, replace or refill it.
Continue turning the
clutch about one-half to
three-quarter turn until
it reaches a firm stop.
Tighten only by hand. Do
not use tools.
Clear burners and check
for bent or kinked gas
hose.
Clean the burners.
Clean the burners.
Let burners burn for 15
minutes with lid closed.
Clean the burners.
Check that the venturi
of the burner is properly
seated in the injector.
Do not use the product
in high winds.
Check that the gas
cylinder is empty. If it is
empty, replace or refill it.
Turn burner knobs to
the off position. Turn
gas valve to "CLOSED."
Leave lid closed and
allow fire to burn out.
Remove and clean all
parts after product has
cooled.
Clean the burners and/or
burner tubes.
49
Publicidad
