Beper P206VEN132 Manual De Instrucciones página 11

Stand Fan with Timer Use Instructions
Cleaning and maintenance cannot be carried out by unsupervised
children. For the safety of children and pets, remove and dispose
of all packaging material before use.
This fan is intended for home use only, as described in this manual.
Any other use is to be considered improper and, therefore, dange-
rous.
Description of product
1. Front grid
2. Closing clips
3. Blade stopper
4. Blades
5. Rear grid stopper
6. Rear grid
7. Motor shaft
8. Swing button
9. Body motor
10. Tilt adjusting screw
11. Timer
Instructions for use
Assembling of fan Fig.A (a-g)
Proceed as shown in pictures from a to g.
Make sure to place the base of the fan on a flat and stable surface.
Important: securely fasten the screws of the base to guarantee a good stability of the fan, and to avoid
dangerous shaking.
If the inner tube cannot be seen from the outside, it could be inserted completely inside the external tube –
proceed to extract it to the desired height.
Operation Fig. B
Select the speed by pressing the relevant key on the control panel.
It is possible to adjust head tilt to regulate the direction of the air flow, by unscrewing the tilt adjustment pin
as shown in fig. B.
Warning: only proceed to adjust tilt when the fan is switched off; do not force the movement, to
avoid breakage of the tilting mechanism.
To activate swing function, press the rotating pin downwards, as shown in fig. B; pull it upwards to deactivate
swing function.
It is possible to set the time of auto shut off of the fan, by rotating the timer knob to the desired setting (from
0 to 60 minutes).
Cleaning
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not spray water or other liquids on the fan in order to protect it.
After cleaning, dry every part before using the appliance.
During the winter and when not in use, keep this appliance in a dry and clean place.
12. Control panel
13. Pipe blocking screw
14. Inner pipe
15. Outer pipe
16. Height adjustment handle
17. L shape screw with washer
18. Base
19. Central disc
20. Central disc blocking screws
21. Grid blocking screw
22. Grid blocking bolt
11
EN