Beeper XR2 Guia De Inicio Rapido página 6

SAFETY
Instructions
Beeper thanks you for your purchase and invites you, before using your product, to read the precautions for use and safety
instructions by consulting the complete installation and user manual available at the address indicated at the bottom of the page,
or by scanning the QR code located on the first and last page of this Quick Start Guide.
• The system operates under 12V direct current (12V DC). Make sure of the polarity of each wire.
• Check before installation if all the elements of the vehicle are working correctly, such as ignition & engine start, ignition codes, lights and headlights,
indicators, heating, air conditioning, door locks... Check after installation that all these same elements are working.
• When you connect the general GROUND of the system, it is very important that this ground is straight and completely stable (no leakage).
• Make sure that the wires passing through tight places are protected by adhesive tape to avoid any excessive twisting and degradation of the plastic
protection of the wire with the risk of bad contacts.
• Make sure that the wires of the system as well as all the security accessories are as well concealed as possible in the vehicle, never forget that you
are installing a security system.
• Use a digital multimeter to locate each of the wire polarities.
• Take care not to disconnect the battery if the vehicle has a code car radio.
• If the vehicle is equipped with an AIRBAG, take care not to disconnect the battery from the vehicle, nor to connect the wires without certainty.
• Remove the dome light fuse when installing the system to avoid draining the battery (doors open).
KIT
components
A
• Siren
B
• Power cable
C
• Indicator LEDs
D
• Remotes x2
Find the complete technical manual on our website at the following address: http:/ /urlr.me/Q184P
6
A
B
C
or by flashing the QR code opposite
D