Floor Steam Cleaner - Fuller 56002 Manual De Instrucciones

1. If necessary, remove the steam generator (3) from the floor
cleaner housing (14) by pushing the release button (2)
upwards and pulling the steam generator (3) forward and
up.
2. Select the required attachment. When using the brush (24),
spatula (26), round brush (25) and nozzle attachment (27),
please ensure the adapter attachment (28) is also being
used.
3. Plug the adapter attachment (28), if required, onto the
steam nozzle (3) of the steam generator (3). When placed
correctly, a "click" will be audible. To remove this attachment,
press the release lever located on the larger side of the
attachment. Press the lever and pull the attachment away
from the steam generator (3).
4. Place the selected attachment on the small nozzle of the
adapter attachment. (28), aligning the arrow found on the
selected attachment with the notch on the adapter attachment
(28). Once aligned, push the selected attachment onto the
adapter attachment (28) as far as possible, then rotate the
selected attachment 90° clockwise. Remove an attachment
by turning it 90° anticlockwise and lifting it of the adapter
attachment (28).
5. Connect the plug (15) with a suitable wall outlet.
6. To switch the appliance on, place the on/off switch (20) in
the position I. The appliance will now heat up.
7. Once the appliance has reached its operating temperature,
steam will be emitted from the appliance when pressing the
steam release button (19) on the steam generator handle.
8. Move the appliance over the surface to be cleaned. Move
it slowly and carefully. Press the steam release button (19)
as required.
9. Once the cleaning process has been completed, switch the
appliance off, by place the on/off switch (20) in the position
0, and disconnect if from the wall outlet. Once cooled down
remove the attachments, remove the water reservoir (12),
empty any remaining water and allow it to dry.

Floor steam cleaner

When using the appliance as a floor steam cleaner, it can only be used with the foot
attachment which has to be used with a floor cloth (22) in this set-up.
NOTE: Before the appliance can be used as a floor steam cleaner, it has to be assembled.
Please follow the steps below.
Steam Mop_56002(02608)_US+ES_IM_V1_130516.indb 8
OPERATION
8
5
3
14
6
15
20
18
5/16/13 5:12 PM