Publicidad
NOTE: For the high-capacity battery, make sure the arrow
EN
on the battery pack aligns with the electronic contact in
the high-capacity battery bay. Slide the battery pack down
into the battery bay (Fig. D1). The two battery release
levers will spring up and outward, at the same time the
red marks I can be seen on the battery release levers,
indicating that the battery pack is securely attached
(Fig.D2).
To remove the battery pack, push the battery release
levers inwards, then pull the battery pack out (Fig. D3).
5.
The power bank will communicate with the battery
pack to evaluate the condition of the battery
pack. When the battery pack meets the charging
conditions, the power bank will begin charging the
battery pack and the hub status indicator and the
battery-bay status indicator (above the inserted
battery pack) will flash green.
6.
Insert more battery packs.
7.
When connecting more power banks to the hub, the
hub will supply power to the power banks in the
order of proximity – the power bank nearest to the
hub is powered first. The flashing green battery-bay
status helps identify which battery pack is currently
charging.
The charging sequence of the battery packs in the
same power bank
◾
If two battery packs are connected to the power bank
at the same time, the battery pack with the lower
voltage level is charged first, once the battery pack
with the lower voltage level has the same voltage level
as the other, the two battery packs are charged at the
same time.
8
56 VOLT PGX
◾
◾
NOTE:
◾
◾
POWER BANK — PGX1400PB
TM
If three battery packs are connected to the power bank
at the same time, the battery pack with the lowest
voltage level is charged first, once the battery pack
with the lowest voltage level has the same voltage
level as the battery pack with medium voltage level,
these two battery packs are charged at the same time.
Once these two battery packs have the same voltage
level as the battery pack with the highest voltage level,
all three battery packs are charged at the same time.
Refer to the figure below.
Voltage Level of the
Voltage Level of the
Battery Pack
When the battery packs are fully charged, the hub
status indicator and the battery-bay status indicators
will glow solid green. The "fuel gauges" on the battery
packs will turn off. It is recommended to disconnect
the hub from the power supply, if it is not going to be
used for a long period of time.
A significantly reduced run time after fully charging a
battery pack indicates that the battery pack is near the
end of its usable life and must be replaced.
The hub and power bank may get warm during
charging. This is part of the normal operation. Charge
in a well-ventilated area.
Charging
Publicidad
