Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING THE STOP POINT / HEIGHT OF THE BLACK DROP
Caution: The black drop can be easily adjusted after the projector and screen
have been positioned so that the projection image is basically aligned with the
screen. The adjustment of this for fine adjustment only and NOT to compensa-
te for general differences in height.
This must be adjusted when setting up the equipment (e.g. height of the screen
on your wall, height of your projector on the sideboard or in a sideboard or in
a lower drawer / pull-out).
The rope tensioning system is designed in such a way that a concave cut of
the projection screen fabric on both side edges from the bottom to the top en-
sures that lateral tension is created over the entire length of the screen fabric.
This is the only way to ensure that the projection surface remains flat. If the
fabric is shortened too much, this tensioning effect is no longer present over all
areas of the fabric and unevenness or waves can form in the fabric, which then
interfere with the UST projection.
Defects caused by changing the factory-set cloth lengths are not covered by
the warranty.
•
In order to adjust the feed length, you can ask your specialist dealer or
celexon directly for separate instructions. These instructions must be fol-
lowed exactly.
•
NEVER change the advance length without precise knowledge of the
procedure. This can cause irreparable damage to your product and is not
covered by the warranty.
•
This type of ultra-short throw fabric is particularly sensitive to incorrect
settings of the cloth length
•
Even the smallest wave formations resulting from changes in the drop
become clearly and disturbingly visible with UST projection.
19
Publicidad
