Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
"F01" displayed on screen
The machine is not fed with water or insufficient water. Check:
•
Faucet is fully open and has enough water pressure.
•
Water inlet pipe is knotted or not.
•
Filtering net of water inlet pipe is blocked or not (refer to maintenance and repair).
•
Water pipe is frozen or not.
Press «Start/Pause» key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale service.).
"F03" displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut down the
machine and disconnect power supply. Check:
•
Drain pipe is knotted or not.
•
Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump).
IMPORTANT: Ensure that the water has cooled before draining the appliance.
•
Drain hose is frozen up.
Plug in the appliance again.
Restart the desired programme. If fault occurs again, please contact with after-sale service
(refer to after-sale service.).
Electronic module fails (F04, F05, F06, F07, F23).
The washer stops when the program is running. The display window shows fault codes from
"F04' to "F07", "F23" .
If fault code "F04" to "F07", "F23" shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press «Start/Pause» key. If fault occurs again, disconnect power supply
and contact with after-sale service.
"F24"displayed on screen
Water level reaches overflow level.
Remove it by pressing «Start/Pause» key and feed water.
Select and start required program. If fault occurs again, disconnect power supply and contact
with after-sale service.
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door (PTC) to check
whether the door is closed.
Open and close it again.
After fault is removed, press «Start/Pause» key. If fault occurs again, disconnect power supply
and contact with after-sale service.
29
EN
Publicidad
