Universal Blue FAMARA 4003SR Manual De Instrucciones página 36

Note:
 If a new tank has just been connected, please allow at least
one minute for the air in the gas pipeline to purge out through
the pilot hole.
 When lighting the pilot flame make sure that the variable
control knob is continuously pressed down while pressing the
igniter button. Variable control knob can be released after the
pilot flame lights.
 Pilot flame can be watched and checked from the small round
window with sliding lid located at the bottom of the flame
screen (to the left or right side of the controller).
 If the pilot flame does not light or it goes out, repeat step 3.
After the pilot flame lights, turn the variable control knob to
maximum position and leave it there for 5 minutes or more
before turning the knob to desired temperature position.
TO TURN OFF THE HEATER
Turn the variable control knob to PILOT position.
Press and turn the variable control knob to OFF position.
Turn off the valve on the gas supply cylinder completely.
Storage
Always close the gas valve of the gas cylinder after use or in
case of a disturbance.
Remove the pressure controller and the hose.
Check the tighness of the gas valve and for damage. If you
suspect damage, have it changed by your gas dealer.
Never store liquid gas cylinder in a sub-terrain, or at places
without adequate air ventilation.
36